Octagon end table – Making an octagon end table is not much different than making a round or oval table, but the payoff it octagon end table are much less common, is that your table will really stand out. If you are new to woodworking, then a small side table or coffee table will make a good starting project. You can learn some of the basic joints in carpentry, as the blunt edge joint, to this project. Those with more experience can adjust the size of the project and make an octagonal breakfast table or kitchen table.
Making octagon end table, Cut a 40- 40-inch square from the wood plate. Divide the square into quarters at the sides; mark it with a cross through the center of each side. Measure 5 centimeters on either side of the midpoints. Cut two block legs from the wood of 15 to 20 centimeters and a base shelf measuring 20 by 20 centimeters. Sand all of the components of the table. Mark a line along the middle of two opposite edges of the frame – then a mark every 5 centimeters on these lines – it should be about 1/2 inch to be displayed.
12 Photos Gallery of: Make Wooden Octagon End Table
Measure 1/2 inch up to an end of a 20-inch from the bone and make marks that direction to 5 centimeters. Drill a whole 1/4 inch deep and wide at each of the points on both the legs and the ends of the chassis. Immerse the dowel pegs in glue; place them into the holes in the chassis. Remove the clamps and centering the frame, the legs, on the lower side of the octagon end table top. Paint or varnish on the table as desired.