Saratoga hickory laminate – Laminate flooring requires no surface preparation, sealant or wood preservatives are generally build into the floors themselves. But to finish a room with laminate flooring. You will probably want to trim each edge. And a contact strip to transition from laminate flooring in the next room. If it does not have the same floor. Finished laminate floor in this way requires a few basic tools, but is not difficult.
Measure the length of the wall in a corner where you have installed the Saratoga hickory laminate floor. Cut a piece of quarter round molding length, by means of a miter saw to cut suitable angle. For example, in the corner where the two walls meet, each bit of the casting must be cut at 45 degrees. With the longest part of the back face where the timber wall. And the cutting angling toward the room side of the trim. For external corner the angle is the opposite, with the longer edge of the wood towards the room and the 45-degree angle cut down the side wall.
12 Photos Gallery of: How to Finish Saratoga Hickory Laminate
Cut all your molding to size in order to complete the room. Except for a few doors or transitions to other types of floor surfaces. Apply a thin line of glue on the back and bottom of each edge stick before putting it in place. Then hammer down with a surface of the nail near each end. And somewhere in the middle your outfit is not flush with the wall. Finish nails have small heads that are nearly invisible when fully hammered out. But you may need to touch up on them with paint or wood-tone color marker in some cases. Especially with curved walls that require more spikes.