End Tables With Drawers – 1st Place skirt pieces on a table. Drill two countersink holes at the ends of the 18-inch pieces. Apply glue to the ends of the 30-inch pieces and secure them between 18- inch pieces with drywall screws to form two 18-by -31 ½-inch boxes. Clean up excess glue immediately with a damp cloth. 2nd step to end tables without drawers idea is drill countersink holes through the 3 ½-inch width of the skirt every 4 inches. Then place tops on the table and draw a line along the edge of the top 1-inch in from the edge.
3rd Apply glue to the top inside the line from step 2. Place the skirt on the lines and secure them to the top with drywall screws. Clean up excess glue immediately with a damp cloth. 4th Place spindle legs in the corners of skirts and mark their statement at the bottom of the top. Remove legs and drilling a countersink hole through to the skirt, so the screw will secure the leg to the skirt. Each leg should get two screws. 5th Apply glue inside the contours you drew in Step 4 and on the two sides of the leg that will meet skirt. Attach the legs to the table through the front of the skirt. Clean up excess glue immediately with a damp cloth. Sand tables before applying finish with 100-grit sandpaper. Your end tables with drawers is finished.